Tunnel的具体配置

GRE Tunnel

The second procedure is to set up the GRE tunnel and route IPX through it to the Cisco 1600. This procedure involves

creating the tunnel interface on both routers. The Ethernet 0 of the Cisco 1600 and the Ethernet 1/1 of the Cisco 7206 are theendpoints of the tunnel. It will be a simple IP GRE tunnel.1. Configure the tunnel interface of the Cisco 7206:central7206#conf t

Enter configuration commands, one per line. End with CNTL/Z.central7206(config)#interface tunnel 0central7206(config-if)#tunnel source e 1/1

central7206(config-if)#tunnel destination 192.168.113.2central7206(config-if)#

%LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to up2. Configure the tunnel interface of the Cisco 1600:home1600#conf t

Enter configuration commands, one per line. End with CNTL/Z.home1600(config)#interface tunnel 0home1600(config-if)#tunnel source Ethernet 0home1600(config-if)#tunnel destination 192.168.114.2home1600(config-if)#

%LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to upIPX through GRE

1. Enable IPX routing on the Cisco 1600:home1600(config)#ipx routinghome1600(config)ipx router rip

home1600(config-ipx-router)#network 1681130home1600(config-ipx-router)#network 1681131

2. Turn on the IPX networks on its Ethernet and tunnel interfaces:home1600(config)#interface ethernet 0home1600(config-if)#ipx network 1681130home1600(config-if)#interface tunnel 0home1600(config-if)#ipx network 1681131

3. Turn on IPX network 1681131 on the tunnel interface of the Cisco 7206:central7206(config)#interface tunnel 0central7206(config-if)#ipx network 1681131

4. Turn on IPX Routing Information Protocol (RIP) on the Cisco 7206, and enable route redistribution:central7206(config)#ipx router rip

central7206(config-ipx-route)#redistribute eigrp 2central7206(config-ipx-route)#network 1681131central7206(config-ipx-route)#ipx router eigrp 2central7206(config-ipx-route)#redistribute rip⽂章录⼊：csh 责任编辑：csh